:: Rolling a 'Windmill' Joint          Print

The windmill is tricky to make but worthwhile the effort.  You can use the windmill again and again and you’ll effectively be smoking four joints at once.

First off find yourself a piece of thin card about 10cm by 10cm.  Roll it into a cone and trim the end so it’s flat.  Then rap the cone in rolling papers to seal it up.  Make sure there’s about 3cm of excess paper left at the end.

Now you need to make a long roach about the length of a pencil.  Then cut the roach in half and remove a section from the centre of each roach.

Now pierce four holes in about 1cm from the top of the card in a cross pattern.  The roaches will go straight through to provide 4 joint holders.

 Now just scrunch the excess paper at the top and tie it off with a piece of string or an elastic band.  Slide a joint in each roach and seal it with either gum from a paper or masking tape.